Auto recovery configuration

Click the Archives > Recovery Settings tab to configure the automatic resynchronization of archives after a temporary outage. To set up archives and realms for auto recovery, refer to the Archives and Realms tabs described in the previous section.

To activate the automatic resynchronization, select Enable Auto Recovery.

You can perform the following actions:

• specify general auto recovery settings

• add / delete custom auto recovery schedule

To specify general auto recovery settings

• Set the following parameters:

  • Maximum Threads: number of threads used for resynchronization of archives per application server

  • Retry Timeout (in Minutes): time in minutes after which a recovery is tried again or tried for the first time

• Click Save. The newly created archive appears in the list.

To add / delete custom auto recovery schedule

• Click Add Schedule. Enter the name of the new schedule in the dialog and click OK. The new tab for the auto recovery schedule appears.

  

• To enable / disable the schedule, select / clear Enabled on the corresponding schedule tab.

• Optionally set a description for the schedule.

• Specify days of the week when a resynchronization of archives should take place by selecting the corresponding check boxes.

• Set Start / End Time when the resynchronization of archives should start / stop on each weekday selected.

• Click Delete Schedule to remove the currently opened custom schedule.

• Click Save to finalize the settings.